Facet Joint Injections


Facet joints are small joints at each segment of the spine that provide stability and help guide motion. The facet joints can become painful due to arthritis of the spine, a back injury or mechanical stress to the back. A cervical (neck), thoracic (upper back) or lumbar (lower back) facet joint injection involves injecting a steroid medication, which can anesthetize the facet joints and block the pain. The pain relief from a facet joint injection is intended to help a patient better tolerate a physical therapy routine to rehabilitate his or her injury or back condition. Facet joint injections usually have two goals: to help diagnose the cause and location of pain and also to provide pain relief.

Diagnostic goals: By placing numbing medicine into the joint, the amount of immediate pain relief experienced by the patient will help confirm or deny the joint as a source of pain. If complete pain relief is achieved while some of the facet joints are numb it means those joints are likely to be the source of pain.

Pain relief goals: Along with the numbing medication, a facet joint injection also includes injecting time-release cortisone into the facet joints to reduce inflammation, which can often provide long term pain relief. The procedure may also be called a facet block, as its purpose is to block the pain.
Anatomy of the Cervical, Thoracic and Lumbar Facet Joints
The facet joints are paired joints in the back and neck, one pair at each vertebral level (one joint on each side of the vertebrae). These joints have opposing surfaces of cartilage (cushioning tissue between the bones) and a surrounding capsule that is filled with synovial fluid, which reduces the friction between bones that rub together.

Cervical facet joints are located on the back or side of the neck. Thoracic facet joints are in the upper back and lumbar facet joints are in the lower back. Depending on which joints are affected, pain can be located in different areas of the body:

Cervical facet joints. Pain caused by cervical facet joints is usually felt in the head, neck, shoulder, and/or arm.

Thoracic facet joints. Pain caused by thoracic facet joints is typically felt in the upper back, chest and/or arm (rarely).

Lumbar facet joints. Pain cause by lumbar facet joints is typically felt in the lower back, hip, buttock, and/or leg.

Cervical, Thoracic and Lumbar Facet Joint Injection Procedure
As with many spinal injections, facet joint injections are best performed using fluoroscopy (live x-ray) for guidance to properly target and place the needle (and to help avoid nerve injury or other injury).

The injection procedure includes the following steps:

  • An IV line will be started so that adequate relaxation medicine can be given, if needed. The patient lies face down on an x-ray table and the skin over the area to be treated is well cleaned.
  • The physician numbs a small area of skin with an anesthetic (a numbing medicine). This may sting for a few seconds.
  • The physician uses x-ray guidance (fluoroscopy) to direct a very small needle into the joint. Several drops of contrast dye are then injected to confirm that the medicine only goes into the joint.
  • A small mixture of anesthetic (such as lidocaine)and anti-inflammatory medication (cortisone) is then slowly injected into the joint.

The injection itself only takes a few minutes, but the entire procedure usually takes between thirty and sixty minutes.After the procedure, the patient typically remains resting on the table for twenty to thirty minutes, and then is asked to move the area of usual discomfort to try to provoke the usual pain. Patients may or may not obtain pain relief in the first few hours after the injection, depending upon whether or not the joints that were injected are the main source of the patient’s pain. On occasion, the patient may feel numb or experience a slightly weak or odd feeling in the upper back for a few hours after the injection. On the day of the injection, patients are advised to avoid driving and avoid doing any strenuous activities.
The patient should record the levels of pain relief during the next week in a pain diary. Tracking the level of pain is helpful to clearly inform the treating physician of the injection results and in planning future tests and/or treatment, as needed.

Facet Joint Injection Results and Follow-up

On the day a patient is to receive a facet joint injection, they are advised to avoid doing any strenuous activities, unless instructed by their physician. The patient should not drive the day of the injection unless approved by the treating physician. If sedation was used, the patient should not drive for 24 hours after the procedure. Patients may notice a slight increase in pain lasting for several days as the numbing medicine wears off and before the cortisone starts to take effect. If the area is uncomfortable in the first two to three days after the injection, carefully applying ice or a cold pack to the general area of the injection site will typically provide pain relief.

If the facet joints that were treated are the source of the pain, the patient may begin to notice pain relief starting two to five days after the injection. If no improvement occurs within ten days after the injection, then the patient is unlikely to gain any pain relief from the injection and further diagnostic tests may be needed to accurately diagnose the patient’s pain.

Patients may continue to take their regular pain medicine after the procedure, with the exception of limiting pain medicine within the first four to six hours after the injection so that the diagnostic information obtained is accurate. Patients may be referred for physical therapy or manual therapy after the injection while the numbing medicine is effective and/or over the next several weeks while the cortisone is working.
On the day after the procedure, patients may return to their regular activities. When the pain is improved, it is advisable to start regular exercise and activities in moderation. Even if the pain relief is significant, it is still important to increase activities gradually over one to two weeks to avoid recurrence of pain.

If the facet block procedure is effective in alleviating the patient’s back pain, it is often considered reasonable for the procedure to be done up to three times per year. However, if the first facet joint injection does not relieve the patient’s pain then the injection should not be repeated.

Frequently Asked Questions

What is a Facet Joint?

  • Facet Joints are joints between the bones of the spine that guide the spine during movement. These joints are on both sides of the spine and are only about the size of a thumbnail.
  • The pain associated with Facet Joints can be a result of injury to the cartilage inside the joint or the connecting ligaments around the joint.
  • Depending on the joint affected, pain can occur in your neck, back, hip, buttock or thigh.

What is a Facet Joint Injection?

  • A Facet Joint Injection can be used to diagnose and/or treat pain.
  • A local anesthetic will be used to numb your skin and then the doctor will insert a very thin needle directly into the joint. Fluoroscopy is used to ensure proper placement of the needle.
  • For diagnostic injections, a local anesthetic will be injected into the joint. If the pain is relieved the doctor will know which joint is causing the pain.
  • For therapeutic injections, a small amount of steroid will be injected into the joint to treat inflammation in the joint.

What are some possible complications to this procedure?

  • Though complications are extremely rare, infection, bleeding, nerve damage, etc can occur.
  • Your doctor will go over all the possible complications, in detail, before the procedure.

When should I expect to feel relief and how long will it last?

  • Due to the local anesthetic, you will feel some pain relief immediately, however, some of the pain may return. This is normal since the local anesthetic wears off before the steroids have time to start working. The steroids usually take 2-3 days to start working but can take up to a week.
  • If there is no underlying bone or joint issue, one injection could bring long term pain relief. In many cases, further treatment may be needed after several months but this depends on the number of injured areas and the amount of inflammation.

What happens after the injection?

  • You will be monitored for up to 30 minutes after the injection. When you are ready to leave, the surgery center will give you discharge instructions. You will also be given a pain diary. It is important to fill this out because it helps your doctor know how the injection is working.
  • It may help to move in ways that hurt before the injection, to see if the pain is still there, but do not over do it. Take it easy the rest of the day.
  • You may feel immediate pain relief and numbness in your back for up to six hours after the injection. This tells you the medication has reached the right spot.
  • Your pain may return after this short pain-free period, or may even be a little worse for a day or two. This is normal. It may be caused by needle irritation or by the corticosteroid itself. Corticosteroids usually take two to three days to start working, but can take as long as a week.
  • You can usually return to work the day after the injection, but always check with your doctor.
Our Locations

Choose your preferred location